Traffic Light Southbound Legacy at El... Log Out | Topics | Search
Moderators | Register | Edit Profile

City of Frisco Question and Answer Board » Frisco Q & A » Traffic Light Southbound Legacy at Eldorado « Previous Next »

  Thread Last Poster Posts Pages Last Post
Traffic Light on Legacy at Cotton GinBen Brezina, Assista09-05-14  12:28 pm
  Start New Thread        

Author Message

Jeff Primeau
New member
Username: Jprimeau

Post Number: 1
Registered: 02-2009
Posted on Thursday, February 12, 2009 - 03:13 pm:   

Is there any way we could extend the timing of the green light going southbound on Legacy at the corner of Eldorado? The left turn signal seems fine but the green light only stays on for a few seconds. I drive there every morning and on average only 4 cars can get through the intersection.

Joel Fitts, Senior Traffic Engineer
Username: Joel_fitts

Post Number: 27
Registered: 03-2008
Posted on Wednesday, February 18, 2009 - 09:59 pm:   


The construction along Eldorado Parkway required the temporary removal of the eastbound and westbound left-turn lanes at the intersection with Legacy Drive, which made traffic signal operations at the intersection less efficient.

After receiving your message, we watched the intersection to see if we could make some adjustments. You might have noticed that we did add some time for the southbound direction this week.

Thank you,
Joel Fitts
Senior Traffic Engineer

Steve Covington, Chief Building Off
Username: Steve

Post Number: 87
Registered: 03-2005
Posted on Tuesday, April 29, 2014 - 09:59 am:   

The Building Inspection Department has seen a record number of roofing permits since the hail storms earlier this month. We urge you to use some caution when choosing a contractor for your roofing project. The North Texas Roofing Contractors Association has some good information for choosing a roofing system and a reputable roofing contractor. Visit their website at

Add Your Message Here
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Options: Enable HTML code in message
Automatically activate URLs in message